
Reference: RBD-1110
Banner
To upgrade the programmer using STM32CubeProgrammer you need to enable the "Shared" options. This product is a clone and might not support STM32Cube.
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
This is ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32.
ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
STM8 applications use the USB full speed interface to communicate with ST Visual Develop (STVD) or ST Visual Program (STVP) software. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.
In addition, to provide the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 Vrms.
To upgrade the programmer using STM32CubeProgrammer you need to enable the "Shared" options.
RoboticsBD RoboticsBD RoboticsBD RoboticsBD RoboticsBD RoboticsBD RoboticsBD RoboticsBD RoboticsBD RoboticsBD
1 x ST-LINK/V2 debugging and programming Unit
1 x USB standard A to mini B cable
1 x Connecting Cable for STM8 SWIM and STM32 JTAG/SWD protocol
1 x Flat ribbon with a standard ERNI connector at one end (A JTAG or SWD and SWV flat ribbon with a 20 pin connector)
Specific References
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Reference: RBD-1110
Reference: RBD-2416
Reference: RBD-2162
Reference: RBD-2412
Reference: RBD-2196
Reference: RBD-1139
Reference: RBD-1830
Reference: RBD-2746
Reference: RBD-2413
Reference: RBD-0412
Reference: RBD-2311
Reference: RBD-0234
Brand: SparkFun Electronics
Reference: RBD-2195
Reference: RBD-1101
Reference: RBD-2198
Reference: RBD-1700
Brand: Waveshare
To upgrade the programmer using STM32CubeProgrammer you need to enable the "Shared" options. This product is a clone and might not support STM32Cube.
check_circle
check_circle