
Reference: RBD-0117
Banner
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening project. There are two 1/2" (Nominal non-taped National Pipe) outlets. Normally, the valve is closed. When 12VDC is applied to the two terminals, the valve opens and water can push through. The valve has a gasket arrangement inside, so there is a minimum pressure requirement of 0.02 Mpa (3 PSI). Also, liquid can only flow one direction.
We tried this solenoid at various DC voltages and found we could actuate it down at 6VDC (although it was a little slower to open). Here is the current draw table for various voltages. We suggest a TIP120 or N-Channel power FET with a 1N4001 kickback diode to drive this from a microcontroller pin. For a power supply, our 9V 1A or 12V 1A power adapters will do the job.
Specific References
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Reference: RBD-0117
Reference: RBD-0436
Reference: RBD-2001
Reference: RBD-0108
Reference: RBD-0319
Reference: RBD-1575
Reference: RBD-0386
Reference: RBD-1917
Reference: 0031
Reference: RBD-1573
Reference: RBD-1539
Reference: RBD-2383
Reference: RBD-0166
Reference: RBD-0034
Reference: RBD-0581
Reference: RBD-0688
check_circle
check_circle