
Reference: RBD-2122
Banner
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
This is a force-sensitive resistor with a round, 30mm diameter, sensing area. This FSR will vary its resistance depending on how much force is being applied to the sensing area.
The harder the force, the lower the resistance. When no force is been applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range of 150g-20kg.
Two pins extend from the bottom of the sensor with 0.1″ pitch making it bread friendly. There is a peel-and-stick rubber backing on the other side of the sensing area to mount the FSR. Just Connect a resistor to form a voltage divider and measure the voltage at the junction to find the force applied.
These sensors are simple to set up and great for sensing force, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
This sensor can easily interface with Microcontrollers, Arduino Boards, Raspberry Pi, etc. using an Analog to Digital Converter (ADC). so to get the best deal on this force sensor at an affordable price buy now.
Note: The color of the product may vary. You may get any color while shipping.
1 x Force Sensor Resistor Thin Pressure Sensor MD30-60 150g-20kg 30mm
Specific References
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Reference: RBD-2122
Reference: RBD-2170
Reference: RBD-0672
Reference: RBD-0355
Reference: RBD-1737
Reference: RBD-0152
Reference: RBD-1348
Reference: RBD-1066
Reference: RBD-1670
Reference: RBD-2227
Reference: RBD-2508
Reference: RBD-2385
Reference: RBD-2498
Reference: RBD-0389
Reference: RBD-1716
Reference: RBD-0687
check_circle
check_circle